The Automatical cut to length line adopts a PLC to control two stepping motors, one is used to drive the two conveying wheels to rotate for wire conveying, and the other is used to drive the wire trough to rotate, so that the finished product in the wire trough can be dumped on the finished product below Slot. The cutting aspect is powered by the air pump, and the PLC controls the solenoid valve to supply power to the cylinder to make it press down and cut.

1 Incoming wire wheel: conveying wire and stripping wire end. When stripping short wires, the stripping machine has both stripping head and stripping tail (wire length less than 50mm). In addition to the stripping head, it also has the function of stripping the middle parts when stripping.

2 Outgoing wire wheel: conveying wire for the wire stripping machine and stripping the wire tail.

3 Inlet wheel gap adjustment knob: adjust the wire inlet wheel gap of the wire stripping machine, turn the gap upward to increase, and rotate it down to decrease the gap

4 Wire stripping machine inlet wheel pressure adjustment knob: Adjust the pressure of the wire inlet wheel of the wire stripping machine. After pulling it out, turn it clockwise to increase the pressure of the inlet wheel. After pulling it out, rotate it counterclockwise to reduce the pressure of the inlet wheel.

5 Raise the knob of the inlet wheel: when the wire stripper is threading, raise the inlet wheel, turn the knob clockwise to raise the inlet wheel so that the wire can be passed smoothly; when working, lower the inlet wheel and turn the knob counterclockwise to lower it. The wire wheel presses the wire.

6 Outlet wheel gap adjustment knob: adjust the outlet wheel gap for the wire stripping machine, turning up the gap increases, turning down the gap decreases

7 Outlet wheel pressure adjustment knob: Adjust the outlet wheel pressure for the wire stripping machine. After pulling it out, turn it counterclockwise, the outlet wheel pressure will increase, and after pulling it out clockwise, the inlet wheel pressure will decrease.

8 Lifting knob of outlet wheel: Raise the outlet wheel when removing the wire, turn the knob counterclockwise to lift the outlet wheel so that the wire can be taken out smoothly; lower the outlet wheel when working, and turn the knob clockwise to lower the outlet wheel.

9 Knife holder assembly: in the wire stripping machine, it is responsible for the cutting, stripping and tailing of the wire. When the machine is stopped, the upper and lower blades need to be opened to the maximum so that the wire can pass through the cutter smoothly.

If you happen to be looking for a automatical cut to length line you might as well learn about Bangzhou Machinery.